Practice Test: Question Set - 13
1. The operating cost of a distillation column at minimum reflux ratio is
- (A) Minimum
- (B) Maximum
- (C) Infinite
- (D) Zero
2. For a single component absorber, the operating line is straight only when plotted in term of __________ units.
- (A) Partial pressure
- (B) Mole ratio
- (C) Mole fraction
- (D) None of these
3. The cooling effect in a cooling tower cannot be increased by
- (A) Increasing the air
velocity over the wet surfaces
- (B) Reducing the humidity
of entering air
- (C) Lowering the
barometric pressure
- (D) None of these
4. Separation of __________ employs gaseous diffusion process.
- (A) N2 and
O2 from air
- (B) Isotopes of uranium
- (C) Isotopes of helium
- (D) SO2 and
air
5. Sodium bicarbonate is produced during soda ash manufacture using a __________ tower.
- (A) Plate
- (B) Baffle
- (C) Packed
- (D) None of these
6. Leaching rate is independent of the
- (A) Agitation
- (B) Temperature
- (C) Particle size
- (D) None of these
7. With increase in temperature, the rate of leaching increases, because the
- (A) Diffusivity of solute
increases
- (B) Viscosity of solvent
decreases
- (C) Thermal conductivity
of solute increases
- (D) None of these
8. Bound moisture is that liquid which exerts an equilibrium vapor pressure __________ that of the pure liquid at the given temperature.
- (A) Less than
- (B) More than
- (C) Equal to
- (D) Either (a) or (b);
depends on the solid
9. The reflux to a distillation column is 100 moles/hr, when the overhead product rate is 50 moles/hr. The reflux ratio is
- (A) 2
- (B) 0.5
- (C) 50
- (D) 150
10. Which of the following is not a batch drier?
- (A) Truck drier
- (B) Agitated pan drier
- (C) Fluidized bed drier
- (D) Vacuum shelf drier
11. Acetic acid will be most economically separated from a dilute solution of acetic acid in water by
- (A) Solvent extraction
- (B) Continuous
distillation
- (C) Evaporation
- (D) Absorption
12. The main reason for dividing a tall packed tower into series of small towers is to
- (A) Minimize the overall
pressure drop
- (B) Avoid flooding
- (C) Reduce liquid hold up
- (D) Avoid channelling
13. The most efficient cooling tower out of the following is
- (A) Induced draft
- (B) Forced draft
- (C) Natural draft
- (D) Atmospheric
14. Molecular distillation is
- (A) High temperature
distillation
- (B) For heat-sensitive
materials
- (C) Very low pressure
distillation
- (D) Both (b) and (c)
15. The value of NA/(NA + NB) for steady state molecular diffusion of gas 'A' through non-diffusing gas 'B' is
- (A) 1
- (B) ∞
- (C) 0.5
- (D) 2
Next Tests: