Marking ITI Machinist Multiple Choice Questions - ObjectiveBooks

Marking ITI Machinist Multiple Choice Questions

Practice Test: Question Set - 01

1. Which one of the following parts of a universal surface gauge helps to draw parallel lines along a datum edge?
    (A) Fine adjusting screw
    (B) Guide pins
    (C) Base
    (D) Rocker arm

2. A divider is used for
    (A) Scribing circles
    (B) Scribing arcs
    (C) Transferring and stepping of distances
    (D) All of the above

3. Which type of rule is used for marking and measuring patterns and hot jobs handled by blacksmith?
    (A) Narrow rule
    (B) Shrink rule
    (C) Hook rule
    (D) Short rule

4. The point angle of centre punch is
    (A) 30°
    (B) 60°
    (C) 90°
    (D) 120°

5. The slots are provided on angle plate for
    (A) Accommodation bolts
    (B) Hanging with hooks
    (C) Reducing weight
    (D) Aligning the work

6. The point angle of Scriber is
    (A) 30°
    (B) 60°
    (C) 5° to 10°
    (D) 12° to 15°

7. Scriber is made of
    (A) Copper
    (B) High carbon steel
    (C) Mild steel
    (D) Cast iron

8. Which of the following is not the part of a combination set?
    (A) Stock
    (B) Protractor head
    (C) Square head
    (D) Centre head

9. 'V' blocks are available in grades of
    (A) 0 and 1
    (B) 1 and 2
    (C) A1 and A2
    (D) 0 and 1 also 1 and 2

10. 'V' block is used to hold round bars. It has a Vee groove which is usually
    (A) 30°
    (B) 60°
    (C) 90°
    (D) 120°

11. Which head is used and set to any required angle in the combination set?
    (A) Square head
    (B) Protractor head
    (C) Centre head
    (D) Rule

12. The tool which is used for laying out large circles is
    (A) Trammel
    (B) Divider
    (C) Jenny caliper
    (D) Scriber

13. During Marking, the reference surface is provided by
    (A) Sketch of the job
    (B) Workpiece
    (C) Marking off table surface
    (D) Surface gauge

Show and hide multiple DIV using JavaScript View All Answers