Practice Test: Question Set - 01
1. Which bolt is used for holding work directly on milling machine?
- (A) T-bolt
- (B) Hexagonal
- (C) Eye bolt
- (D) Square bolt
2. What should be the Tolerance on jig?
- (A) 10-15% of
the Tolerance on the job
- (B) 20-50% of
the Tolerance on the job
- (C) 05-10% of
the Tolerance on the job
- (D) 50-100% of
the Tolerance on the job
3. Which of the following part of shaping machine holds & supports the work piece?
- (A) Base
- (B) Cross rail
- (C) Table
- (D) Column
4. Name the machine, where arbor is used to hold cutter for saving time?
- (A) Boring
machine
- (B) Drilling
machine
- (C) Milling
machine
- (D) Lathe
machine
5. Why fixture is used as a production device?
- (A) Hold work
piece
- (B) Locate work
piece
- (C) Holds &
locate the work piece
- (D) Rotate wok
piece
6. Drill jig bushing is generally made of?
- (A) Cast Iron
- (B) Tool steel
- (C) Cast Steel
- (D) Mild Steel
7. Which of the following tables are used in milling machine?
- (A) Trapezoidal
- (B) Circular
- (C) Rectangle
- (D) Square
8. Which among the following locators is best suitable for location of a round shape job?
- (A) ‘V' locater
- (B) Pin type
locater
- (C) Adjustable
stop locator
- (D) Wedge type
locator
9. Which jig is used for drilling on thin sheet?
- (A) Table jig
- (B) Post jig
- (C) Sandwich jig
- (D) Solid jig
10. Which of the following is not holding device, in milling machine?
- (A) ‘V' block
- (B) Tail stock
- (C) Fixture
- (D) Collets
11. What part carries tool head in shaping machine?
- (A) Table
- (B) Column
- (C) Cross rail
- (D) Ram
12. Name the job holding device in shaping machine?
- (A) Cross rail
- (B) Vice
- (C) Ram
- (D) Column
13. How many cutters at a time milling machine can hold?
- (A) Multi cutter
- (B) Only one
- (C) Only two
- (D) Only three
14. Which of the following is used to guide the tool & hold the job in mass production?
- (A) Jig
- (B) Fixture
- (C) Housing
- (D) Gauge
15. Size of the milling machine is given by the dimension and maximum travel in three directions of which part?
- (A) Cutter
- (B) Arbor
- (C) Column
- (D) Work table
16. Which of the following part of shaper is used to hold the tool?
- (A) Tool head
- (B) Ram
- (C) Vice
- (D) Rail
17. Which device is used in sharping machine to hold the cylindrical work piece?
- (A) Plummer
block
- (B) Square block
- (C) ‘U' block
- (D) ‘V' block
18. Which of the following jig made from a single block of steel to drill small work piece?
- (A) Box jig
- (B) Channel jig
- (C) Angle jig
- (D) Solid jig