Engineering Wood Objective Type Questions - Set 02 - ObjectiveBooks
Engineering Wood Objective Type Questions - Set 02

Engineering Wood Objective Type Questions - Set 02

Practice Test: Question Set - 02

1. The correct depth for a dado is usually _______ the thickness of the stock.
    (A) One-fourth
    (B) One-half
    (C) Three-fourths
    (D) Twice
2. Box joint is another term for a ______ joint.
    (A) Surface-lap
    (B) Cross-lap
    (C) Finger-lap
    (D) Full-lap
3. The width of the mortise should be the same as the _______ of the tenon.
    (A) Width
    (B) Length
    (C) Thickness
    (D) Radius
4. There are three basic steps to installing a drawer in a table: ______, making the drawer, and installing drawer guides.
    (A) Cutting a rabbet
    (B) Cutting the rail
    (C) Measuring the lip
    (D) Drilling for brackets
5. When making edge joints, pieces of stock wider than _______ inches should be ripped into narrower strips and the strips glued together.
    (A) 2 to 4
    (B) 4 to 6
    (C) 6 to 8
    (D) 8 to 10
6. Boyle’s law refers to the relationship between
    (A) Adhesion and cohesion
    (B) Volume and pressure of gases
    (C) Heating and cooling
    (D) Veneers and laminates
7. Which of the following is not a softwood?
    (A) Pine
    (B) Redwood
    (C) Birch
    (D) Cedar
8. Which type of gloves should be worn when working with sharp edges and rough materials?
    (A) Plastic
    (B) Lightweight cotton
    (C) Leather or thick fabric
    (D) Rubber
9. The reciprocating saw is used primarily for
    (A) Rough cutting
    (B) Curved cuts
    (C) Finish cutting
    (D) All of the above
10. Which of the following is not recommended for planing?
    (A) If you are right handed, grasp the knob in your left hand
    (B) Lift the plane off the board on the return stroke
    (C) Always plane with the grain
    (D) None of the above
11. When making a dowel joint in a frame, use a _______ to locate the dowels on the face surface.
    (A) Gouge
    (B) Try square
    (C) Straightedge
    (D) Tape measure
12. To lay out a dado, superimpose the end of the second board across the _______ of the first.
    (A) Face
    (B) End
    (C) Edge
    (D) None of the above
13. The end of each piece in a miter joint is commonly cut at an angle of ______ degrees.
    (A) 90
    (B) 30 or 60
    (C) 45
    (D) None of the above
14. Hand tools used to cut a mortise include a drill and a
    (A) Chisel
    (B) Dado cutter
    (C) Miter box
    (D) All of the above
15. A screw-mate drill and countersink can be used with
    (A) Dowel screws
    (B) Wood plugs
    (C) Flathead screws
    (D) Roundhead screws
Show and hide multiple DIV using JavaScript View All Answers
 Next Tests: