Methods of working on Wood MCQ - Set 05 - ObjectiveBooks

Methods of working on Wood MCQ - Set 05

Practice Test: Question Set - 05

1. Butt joints can be strengthened using corner blocks, biscuits, dowels, or
    (A) Straps
    (B) Metal fasteners
    (C) Joists
    (D) Tape

2. Trim excess stock from a rabbet using a
    (A) File
    (B) Chisel
    (C) Jigsaw
    (D) Sanding block

3. When pieces of different thicknesses are joined, a ______ joint is used
    (A) Surface-lap
    (B) Cross-lap
    (C) Finger-lap
    (D) Full-lap

4. When using a router with a jig and dovetail bit,
    (A) Begin cutting from left to right
    (B) Certain joints must be cut on certain sides of the jig
    (C) Label the jig as well as the workpieces so that all parts match properly
    (D) All of the above

5. The two basic types of hardware are cabinet hardware and
    (A) Surface hardware
    (B) Structural hardware
    (C) Metal fasteners
    (D) Metal guides

6. All veneer slices cut from a single log are kept in bundles called
    (A) Books
    (B) Collections
    (C) Flitches
    (D) Cuts

7. The jointer is used to ______ boards.
    (A) Straighten
    (B) Smooth
    (C) Square up
    (D) All of the above

8. The elevating crank is used to adjust
    (A) Cutting width
    (B) Angle of cut
    (C) Depth of cut
    (D) None of the above

9. Cutting several pieces at one time is called _______ sawing.
    (A) Pad
    (B) Duplicate
    (C) Repeat
    (D) Pattern

10. Multispur bits are used
    (A) To cut perfectly round, flat-bottomed holes
    (B) To create countersinks
    (C) To cut dowels
    (D) To cut rough holes

11. A worker who finishes plans begun by an architect is a
    (A) Millwright
    (B) Precision woodworker
    (C) Forestry technician
    (D) Drafter

12. Which of the following is not used as a marking tool?
    (A) Scratch awl
    (B) Triangle
    (C) Lead pencil
    (D) Utility knife

13. Butt joints are made by joining together the edge, end, or face surface of one piece of wood to the _______ of another.
    (A) Edge
    (B) End
    (C) Face surface
    (D) All of the above

14. When cutting a rabbet by hand, make the shoulder cut with a
    (A) Backsaw
    (B) Dovetail saw
    (C) Reciprocating saw
    (D) Sharp file

Show and hide multiple DIV using JavaScript View All Answers

 Next Tests: