Uses of Wood in Engineering in Modern Designs - Set 03 - ObjectiveBooks
Uses of Wood in Engineering in Modern Designs - Set 03

Uses of Wood in Engineering in Modern Designs - Set 03

Practice Test: Question Set - 03

1. Which of the following can be used to cut veneer?
    (A) Craft knife
    (B) Utility knife
    (C) Paper cutter
    (D) All of the above
2. Side drawer guides require ________ inch clearance on each side.
    (A) 1/8
    (B) 1/4
    (C) 1/2
    (D) 3/4
3. When edge jointing, hold the work face of the stock flat against the _________ throughout the operation.
    (A) Fence
    (B) Outfeed table
    (C) Pressure control
    (D) T-bevel
4. To make a miter cut, adjust the miter gauge to the correct angle and proceed as for
    (A) Ripping
    (B) Crosscutting
    (C) Chamfering
    (D) Cutting a taper
5. The radial-arm saw is sometimes called a ______ saw.
    (A) Cutoff
    (B) Table
    (C) Combination
    (D) Back
6. The compound miter saw is referred to as “compound” because
    (A) It can do both crosscutting and ripping
    (B) There is more than one miter gauge installed on the saw table
    (C) It can cut two angled surfaces at the same time
    (D) It can cut from above or below the workpiece
7. When making intricate internal cuts,
    (A) Drill a relief hole in the center of the waste stock
    (B) Run the blade through a relief hole
    (C) Adjust the guide to the correct height
    (D) All of the above
8. Large machines with two belts arranged on three pulleys are capable of _______ speed settings.
    (A) Three
    (B) Six
    (C) Nine
    (D) Twelve
9. During sanding, the movement of the abrasive against the wood generates
    (A) Static electricity
    (B) Adhesion
    (C) Friction
    (D) Tension
10. The first step in lumber processing is called
    (A) Selective cutting
    (B) Barking
    (C) Air drying
    (D) Kiln drying
11. Which of the following would not be found on a bill of materials?
    (A) Finished size of each wood part
    (B) Rough size of each wood part
    (C) Fasteners
    (D) Accessories
12. A power drill for woodworking should be variable speed and
    (A) Cordless
    (B) Reversible
    (C) Heavy
    (D) All of the above
13. When using dowels to strengthen joints, their diameter should never be more than _______ the thickness of the wood
    (A) Half
    (B) One-quarter
    (C) Twice
    (D) Three-fourths
14. Do not allow your fingers to come closer than ________ inches to the blade on a table saw.
    (A) 2
    (B) 3
    (C) 4
    (D) 5
15. A ______ is used to hold the glass in place in a picture frame.
    (A) Rabbet edge
    (B) Dowel
    (C) Dado
    (D) Metal clip
Show and hide multiple DIV using JavaScript View All Answers
 Next Tests: