Computer Science Engineering Automation System - Set 08 - ObjectiveBooks
Computer Science Engineering Automation System - Set 08

Computer Science Engineering Automation System - Set 08

Practice Test: Question Set - 08

1. An intelligent robot can:
    (A) Make decisions
    (B) Handle only small payloads
    (C) Walk
    (D) Speak
2. Which of the following may be classified as an automation system?
    (A) Automated warehouses
    (B) Numerically controlled machine tools
    (C) Robotics
    (D) All of the above
3. Which of the plotters listed below eliminates media size limitations?
    (A) Drum
    (B) Flatbed
    (C) Electrostatic
    (D) Pinch roller
4. The concept of a general CAD system was that it should provide:
    (A) A system for handling user actions
    (B) A system for the operation of applications programming
    (C) A set of basic system functions and utilities
    (D) All of the above
5. A venturi tube:
    (A) Is extremely difficult to use
    (B) Is made only of metal
    (C) Measures the presence of a liquid
    (D) Can be used to measure gas or liquid flow rates
6. Which of the following is required for a plotter to perform specific commands?
    (A) Firmware
    (B) Software
    (C) Driver
    (D) Hardware
7. The accuracy of a pick-and-place robot can be as good as:
    (A) + 0.0005 inches
    (B) + 0.05 inches
    (C) 0.008 inches
    (D) + 3%
8. The three different types of pen plotter technology are flatbed, drum and:
    (A) Electrostatic
    (B) Thermal
    (C) Pinch roller
    (D) Impact
9. A proportional plus integral controller can:
    (A) Has no transient response
    (B) Can compensate for lag
    (C) Can increase the system type
    (D) Both (b) and (c)
10. What is required to enable the PC to emulate a graphics terminal?
    (A) Software
    (B) A laser printer
    (C) A color monitor
    (D) A graphics board
11. Analog and digital controllers:
    (A) Cost the same to build
    (B) Accept the same input signals
    (C) Can be changed with equal case
    (D) None of the above
12. Most current PC CAD systems are used for producing:
    (A) Solids modeling
    (B) 2-D drawings
    (C) Circuit simulation
    (D) Finite element analysis
13. Which of the following is a graphical output device?
    (A) Dot-matrix Printer
    (B) Plotter
    (C) Laser Printer
    (D) Line Printer
14. Which of the following elements can be used with a TI510 FC?
    (A) Drum timer
    (B) Metronome
    (C) Cymbal timer
    (D) Flashing light
15. The addition of ________ can reduce processing time.
    (A) A buffer
    (B) An EPROM
    (C) A converter
    (D) A co-processor
Show and hide multiple DIV using JavaScript View All Answers
 Next Tests: