Practice Test: Question Set - 02
1. Forepoling method is generally adopted for tunnelling in:
- (A) Soft
ground
- (B) Firm
ground
- (C) Running
ground
- (D) None of
these
2. In Belgium method of tunnelling
- (A) Construction
of side walls is completed before invert and roof arch are built
- (B) Construction
of roof arch is completed before side walls and inverts are built
- (C) Construction
of invert is completed before side walls and roof arch are built
- (D) Construction
of invert and side walls is completed before roof arch is built
3. For full face method, the excavation to be done is generally divided into
- (A) Two sections
- (B) Three
sections
- (C) Four
sections
- (D) Five
sections
4. In the given figure drill holes, heading, mucking and benching are numbered as 1, 2, 3, 4; The correct sequence is:
- (A) 4, 1, 2, 3
- (B) 1, 2, 3, 4
- (C) 4, 1, 3, 2
- (D) 3, 4, 1, 3
5. In “full face” method of constructing tunnels, the first operation relates to
- (A) Removal
of bottom portion
- (B) Excavation
of one drift in the centre
- (C) Removal
of top portion
- (D) Excavation
being done along the periphery
6. American method of tunnelling
(i) Is
suitable for large sized tunnels
(ii) Is not
suitable for railway or highway tunnels
(iii)
Requires heavy timbers
Of these
statements
- (A) Only (i) is
correct
- (B) (i) and
(iii) are correct
- (C) (ii) and
(iii) are correct
- (D) (i) and (ii)
are correct
7. For hauling muck from the tunnel, the following type of muck-car is used:
- (A) Muck box
- (B) Side dump
car
- (C) U-bottom
- (D) All of these
8. Which one of the following statements is not correct with regard to heading and henching method of tunnelling?
- (A) Driving of
tunnel is done in two portions of its section
- (B) Driving the
top portion is done in advance of the bottom portion
- (C) The
holes in head and bench are loaded together with explosive for blasting
- (D) Firing of
head holes is done just before the bench holes are fired
9. Which one of the following methods of tunnelling does not require the use of time bearing?
- (A) Linear plate
method
- (B) Shield
method
- (C) Compressed
air method
- (D) All of these
10. Which one of the following linings is suitable for shield driven tunnels particularly in the sub-aqueous regions?
- (A) Brick lining
- (B) Stone
lining
- (C) Timber line
- (D) Cast iron
lining
Next Tests: