Practice Test: Question Set - 10
1. The condition of a part when it contains the least amount of material is referred to as ________.
- (A) Smallest
- (B) LMC
- (C) MMC
- (D) Actual size
2. These units are based on inch-foot and yard measurements:
- (A) International
customary units
- (B) U.S. metric
units
- (C) U.S.
customary units
- (D) ISO
international units
3. In offset sections, offsets or bends in the cutting plane are all:
- (A) 90 degrees
- (B) 180 degrees
- (C) Either 90 or
180 degrees
- (D) 30, 60 or 90
degrees
4. In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
- (A) Primary
- (B) Secondary
- (C) Revolved
- (D) Partial
5. When designing a home for a client, one of the most important pre-design considerations that an architect needs to address is ________.
- (A) How
much money the client is willing to spend
- (B) The
site on which the house is to sit
- (C) The
nearest grocery store
- (D) Whether
or not there is a curb and gutter system
6. Placement of dimensions on a drawing is controlled by ________.
- (A) ANSI
- (B) The
design engineer
- (C) Corporate
drafting standards
- (D) All of the
above
7. In the section view, the areas that would have been in actual contact with the cutting plane are shown with:
- (A) A cutting
plane line
- (B) Section
lining
- (C) Visible
lines
- (D) Lines
and arrows
8. This is how axonometric, oblique, and perspective sketches show objects:
- (A) Orthographically
- (B) Pictorially
- (C) Obliquely
- (D) Parallel
9. This is used to indicate that a surface is to be machined:
- (A) Finish mark
- (B) Machining
mark
- (C) Roughness
indicator
- (D) Coordinate
mark
10. A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.
- (A) Offset
- (B) Half
- (C) Whole
- (D) Broken out
11. This means that a feature of a finished product contains the maximum amount of material permitted by the tolerance dimensions for that feature:
- (A) Maximum
material condition
- (B) Machined
material condition
- (C) Maximum
machined indication
- (D) Machine
mark indication
12. Angles project true size only when the plane containing the angle and plane of projection are this:
- (A) Adjacent
- (B) Aligned
- (C) Perpendicular
- (D) Parallel
13. A back or backing weld is a type of:
- (A) Groove
weld
- (B) Resistance
weld
- (C) Arc
and gas weld
- (D) Upset
weld
14. A typical set of mechanical working drawings includes ________.
- (A) Exploded
assembly
- (B) Part
details
- (C) Parts list
- (D) All
of the above
15. This is the range of digital or hard copy documents that specify the physical function requirements for a product:
- (A) Product
design
- (B) Product
definition
- (C) Drawing
definition
- (D) Engineering
design
Next Tests: